Runco XtremeProjection X-450d Installation & Operation Manual page 108

Operation
• E-Mail Notification: Select E-Mail Notification from the Network menu to specify
when and to whom the Dimension Digital Controller sends error and service notification
messages via e-mail.
The notification messages are in the following format:
To: [E-Mail Address; see below]
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DC-300
Body:
This is an automated message sent from the Runco DC-300:
Notification:
Detailed Description: [ If a DC-300 Error, one of the following:
Serial Number:
Customer Information: [From "Customer Information" sub-menu;
Best Regards,
Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
• E-Mail Address: To specify the destination e-mail address for error and service
notifications, select E-Mail Address from the E-Mail Notification menu. The
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 90). Enter up to 45 alphanumeric characters.
• Error Notification: To have the Dimension Digital Controller send a message to the
destination e-mail address when a "DC-300 Error" or "Display Error" occurs, select
Error Notification from the E-Mail Notification menu and set it to On.
• Error Notification to Runco: To have the Dimension Digital Controller send an
e-mail message to Runco Customer Support when a "DC-300 Error" or "Display
Error" occurs, select Error Notification to Runco from the E-Mail Notification menu
and set it to On.
[One of the following:
"DC-300 Error" / "Display Error"
"Periodic Service Notification"
"Lamp Life Notification" / "Calibration Data"]
"Fan Failure 1" / "Fan Failure 2"
"Overtemp 1" / "Overtemp 2"
"Initialization Failure"
If a Display Error, a device-specific
error message such as "Lamp Door Open"
If a Periodic Service Notification, the elapsed
time since the last notification
If a Lamp Life Notification, the number of hours
the lamp has been in service
If a Calibration Data message,
"See Attached File" ]
[Dimension Digital Controller serial number]
see below]
92 Runco X-400d/X-450d Installation/Operation Manual