Table of Contents
Advertisement
Table 3-6. D-73d Optical Alignment Procedure (with Anamorphic Lenses) (continued)
DHD
1.
Select Aspect Ratio and set it to Cinema.
2.
Select Calibration -> Image Alignment
-> Corner Alignment and adjust corners.
3.
Select Calibration -> Image Alignment
-> Midpoint Alignment and adjust
midpoints.
If you are installing a D-73d/CineWide with AutoScope, install the anamorphic lenses as
described in the section entitled D-73d/CineWide or D-73d/CineWide with
AutoScope - Shasta Anamorphic Lens Installation on page 57. Ensure that the
AutoScope lens motor power switch is in the "off" position and the lenses are out of the
light path.
Insert the provided hex wrench into
the lens lock access hole at the
front of the projector. Then, turn the
wrench counterclockwise two or
three full turns to unlock the lens.
Do this for both primary lenses.
Do not attempt any primary lens adjustments when the lenses are
Caution
locked. Doing so may cause damage to the zoom or lens shift
mechanisms.
1. Power up your source components.
2. Connect an active, 1080p source to the HDMI 1 input on the 3Dimension Processor
if you have not already done so.
The HDMI 1 input must be connected to an active 1080p source
Note
for the optical alignment procedure that you will perform later.
D-73d Series Installation/Operation Manual
Projector
No adjustment needed.
END
Projection
Lens
Lens Lock
53
Note: The DHD Controller saves the
Image Alignment (warp) settings for each
aspect ratio. To program additional
aspect ratios, select each one and use
the controls in the Corner Alignment
and Midpoint Alignment menus. Or,
select Calibration -> Copy/Paste ->
Aspect Ratio -> Copy Settings, select
a different aspect ratio and choose
Paste Settings.
Anamorphic Lens
Installation
(D-73d/CineWide with
AutoScope Only)
Unlocking the Primary
Lenses
Horizontal
Lens Shift
Vertical
Lens Shift
Turning on the Power
Installation
Advertisement
Table of Contents
Troubleshooting
