Changing To Two Or Three Thread Serging With Spreader - Janome CompuLock Instruction Book

13
15
1
2
2
13
14
1
3
A
13 Draw the thread with a pair of tweezers
through the hole in the double chain looper
10 cm (4") or more. Next, make sure that the
needle thread is not tangled in the double
chain looper. Close the looper cover.
15
X = incorrect
O = correct
13 Double chain looper
14 Tweezers
15 Needle thread
Changing to Two or Three Thread Serging
with Spreader
If you want to do two or three thread serging
with the spreader, use one or two needle
threads and the lower looper thread.
1 To attach the spreader
Slide the spreader down into the holder and put
the tip of the spreader into the hole in the upper
looper.
1 Spreader
2 Upper looper
3 Holder
2 To remove the spreader
Pull tab A on the holder toward you lightly.
Push the bottom of the spreader up and pull it
out.
23