Icom IC-E208 Instruction Manual page 19

r NARROW MODE INDICATOR (p. 63)
Appears when the FM/AM narrow mode is selected.
t AM INDICATOR (p. 63)
Appears when AM mode is selected.
y SQUELCH ATTENUATOR INDICATOR (p. 16)
Appears when the squelch attenuator function is activated.
• The attenuator can be switched OFF in initial set mode. (p. 62)
u AUTO POWER-OFF INDICATOR (p. 61)
Appears while the auto power OFF function is in use.
i AUDIO MUTE INDICATOR (P. 18)
Appears when the audio mute function is activated.
• The mute can only be switched ON and OFF from the HM-133
only.
o FREQUENCY READOUT
Shows the operating frequency, channel names, set mode
contents, etc.
• Frequency decimal point blinks while scanning. (p. 40)
• "d" appears in place of the 1st digit while the DTMF memory
function is in use. (p. 47)
!0 PRIORITY INDICATOR (p. 46)
Appears while the priority watch is activated; blinks while
the watch is paused.
!1 MEMORY CHANNEL NUMBER INDICATORS
➥ Shows the selected memory channel number. (p. 25)
➥ Shows the selected bank initial. (p. 34)
➥ "C" appears when the call channel is selected. (p. 37)
➥ "L" appears when the lock function is activated. (p. 14)
PANEL DESCRIPTION
!2 SKIP INDICATORS
➥ "~"appears when the displayed memory channel is
specified as a skip channel. (p. 43)
➥ "P ~" appears when the displayed frequency is spec-
ified as a program skip frequency. (p. 43)
!3 MEMORY INDICATOR (pgs. 11, 25)
Appears when memory mode is selected.
!4 S/RF INDICATORS
➥ Shows the relative signal strength while receiving sig-
nals. (p. 15)
➥ Shows the output power level while transmitting. (p. 17)
!5 OUTPUT POWER INDICATORS
"LOW" appears when low output power; "MID" appears
when middle output power is selected.
No indicator appears when high output power is selected.
!6 BUSY INDICATOR
➥ Appears when a signal is being received or the squelch
is open. (p. 15)
➥ Blinks while the monitor function is activated. (p. 15)
1
1
4