Page 3
COVER GASKET INSTALLATION/ REPLACEMENT
To seal against environmental hazards of outdoor operation,
the Cover Gasket (Pt. No. 25605600) must be in good
condition and installed correctly.
CAUTION: If the Cover Gasket is crimped, damaged or
incorrectly installed, rain will leak into the unit,
causing severe damage, and voiding the
warranty. REPLACE ANY DAMAGED GASKET.
a. Remove the unit from the wall or other mounting surface.
b. Place the Cover Assembly on a flat horizontal surface with
the recessed side up. Carefully seat the Gasket in the
recess of the Cover; refer to FIG–2.
c. Reconnect connectors as necessary. With the Gasket side
of the Cover Assembly up, insert the case into the recess.
d. Replace the four (4) Cover screws. Snug down, but do
not overtighten the screws; excessive force can break
the plastic enclosure material.
For assistance, call RITRON at 800-872-1872, or go to http://www.ritron.com
®
Quick Talk Features/ Applications Manual
+
+
+
FIG–2: COVER ASSEMBLY
Page 3
COVER GASKET
(IN THE RECESS)
+
+
+
Page 3
Page 3