These replacement and optional items are available from 6. In general, the switches you connect to the Quick Talk Ritron and its authorized dealers. are to be independent dry contact switches, and not...
QUICK TALK MODELS AND FREQUENCIES The Quick Talk is a radio transmitter that reports There are two Quick Talk models, one for each of the most changes in the status of switches by transmitting user- popular professional radio communications bands. The...
When the strain relief fitting is used with unit, which is used by the owner to program Quick Talk recommended cable sizes, it provides a water-resistant voice messages and other settings.
(check the Color Dots on your radios and the Most special office telephones, speaker phones, Quick Talk), and you do not use a form of Quiet Call coded and telephones with lighted dials usually cannot be squelch, you can connect your switch to the terminals used to program the Quick Talk.
Do I need to program my Quick Talk's transmitter 154.540 frequency? The original factory-programmed transmitter 154.515 frequency of your Quick Talk is marked on the outside of 154.655 the shipping box, and is also indicated by a color dot on the 151.685 inside the unit case.
114.8 code that is transmitted with the voice messages. 177.3 118.8 No Tone 123.0 Do I need to program my Quick Talk with a Quiet Call 183.5 127.3 Code? Your radio system may or may not use coded 189.9 131.8 squelch signaling.
Normal Invert Normal Invert Do I need to program my Quick Talk with a Digital Quiet Call code? If your radio system does not use Digital Quiet 174 ..074 445 ..043 Call, or any other tradename equivalent, skip this section 025 ..
ONNECT THE STANDARD MODULAR PLUG ONLY TO A TELEPHONE SET — SWITCH 1 CONNECT TO O NOT CONNECT IT TO SWITCH #1 A TELEPHONE LINE TERMINALS. — EXT. PWR. For assistance, call RITRON at 1-800-872-1872, or go to < http://www.ritron.com > Page...
Otherwise, the begin speaking . . . Quick Talk transmitter will be on for the full eight seconds, b. Record a phrase no longer than eight seconds, regardless of the actual message length.
......3 times quarter of an hour, or until the vehicle leaves......4 times Do I need to program this feature? The Quick Talk is set ......5 times at the factory to transmit switch status messages without ......
Quick Talk ensures that all of internal clocks and counters are set properly. Do I need to restart the Quick Talk? It is best if you do. To Leave Telephone Programming Mode and Restart the Quick Talk: •...
Duracell MX1500B, Eveready E91, Rayovac 815 or internal jack on the Quick Talk. equivalent. 2. Test the operation of the Quick Talk before putting it NOTE: Refer to the Advanced Features Owner's Manual into service by activating the switch and listening to the for information on using rechargeable NiCad AA message(s) received on your radio.
You must retain your sales or lease receipt • Any products not furnished by RITRON which are attached or used with the covered (or other written evidence of the date of purchase) and deliver it along product, or defects or damage from the use of the covered product with equipment with the product.