•
EFFECT: PARAM TRACE^SIZE is ignored, so the trace file is opened with the default size.
•
ACTION: Reorder the PARAM list. STNCOM commands can be used to stop and restart the trace using the
desired size without shutting down STN.
zstn-evt-reply-error
"<STN process name> Reply error <2>"
•
CAUSE: An unexpected file system error <2> was returned by REPLYX.
•
EFFECT: Usually none, unless other errors are noted.
•
ACTION: If the problem persists, contact support.
zstn-evt-stopping
"<STN process name> Process stopping - SHUTDOWN command"
•
CAUSE: The STNCOM command SHUTDOWN was entered.
•
EFFECT: The STN process terminates. The backup process, if any, is stopped first. Any active sessions are
immediately terminated.
•
ACTION: Restart STN.
zstn-evt-cpuswitch
"<STN process name> Primary process stopping - CPUSWITCH command"
•
CAUSE: The STNCOM command CPUSWITCH was entered.
•
EFFECT: A backup takeover occurs, and the old primary becomes the new backup.
•
ACTION: None; informational only.
zstn-evt-enter-debug
"<STN process name> Process entering debug"
•
CAUSE: The STNCOM command DEBUG was entered.
•
EFFECT: The STN process enters inspect/debug at its current home terminal. This will suspend all STN
operation and can timeout any active sessions if the debug state is not exited within a short time.
•
ACTION: The DEBUG command is generally used only by development and support staff.
zstn-evt-exit-debug
"<STN process name> Process exiting debug"
•
CAUSE: An inspect session from a previous DEBUG command finished.
•
EFFECT: STN operation continues. Active sessions may timeout if the time spent in inspect mode was too
long.
•
ACTION: None; informational only.
268 • STN Reference
value is
21
value is
22
value is
23
value is
24
value is
25
HP NonStop SSH Reference Manual