HP NonStop SSH 544701-014 Reference Manual page 261

zstn-evt-stop-process
"<STN process name> STN window <2> stopping process <3> status <4>"
•
CAUSE: A dynamic session terminated and KILL_DYNAMIC is set to Y.
•
EFFECT: STN terminates the application which it started at the beginning of the session.
•
ACTION: None. Information only.
zstn-evt-param-license
"<STN process name> STN using PARAM LICENSE <2>"
•
CAUSE: STN is starting up with PARAM LICENSE specified.
•
EFFECT: The specified license file is used instead of the default.
•
ACTION: None. Information only.
zstn-evt-license-pty-ok
"<STN process name> STN will permit PTY/SSH sessions without a Telnet LICENSE"
•
CAUSE: See zstn-evt-license-exception value is 1004
•
EFFECT: See zstn-evt-license-exception value is 1004
•
ACTION: None. Informational only, to emphasize that PTY/SSH sessions are still allowed regardless of the
license exception.
zstn-evt-pool-used
" <$pname> STN Buffer pool used <2> <3>% , used=<4>kw size=<5>kw"
Indicates STN memory pool usage goes above 80%, or back down below 80%.
<2> is "OVER" or "UNDER"
<3> is the threshold percentage as sent by the POOL_WARNING command (default 80)
<4> is the current amount of memory used (unit=1024 words)
<5> is the total size of the pool (unit=1024 words) as configured by PARAM POOL_SIZE
Every minute STN checks the pool usage; if the percentage has changed from over to under the warning level, or under
to over, the EMS event is displayed. The EMS event is also displayed once at startup time. Due to fragmentation, usage
cannot reach 100%, and 80-90% is usually the maximum.
Use the POOL command to monitor pool usage. For larger configurations, increase PARAM POOL_SIZE.
zstn-evt-th-open-err
"<1> Open TH <2> error <3>"
<1> - STN process name
<2> - Terminal Handler process name
<3> - Guardian open file error code
HP NonStop SSH Reference Manual
value is 1028
value is 1029
value is 1030
value is 1033
value is 1034
STN Reference • 261