Fixing Installation Plate(Standard Type) - Heat Controller DMH18DB-1 Service Manual

Fixing Installation Plate
The wall you select should be strong and solid
enough to prevent vibration
1. Mount the installation plate on the wall with
type "A" screws. If mounting the unit on a concrete
wall, use anchor bolts.
• Mount the installation plate horizontally by aligning
the centerline using a level.
2. Measure the wall and mark the centerline. It is also
important to use caution concerning the location of
the installation plate. Routing of the wiring to power
outlets is through the walls typically. Drilling the
hole through the wall for piping connections must
be done safely.
CHASSIS
(Grade)
A
S4 50(1.97)
Distance (mm/inch)
B C D
105(4.13) 59(2.32) 105(4.13)
Installation Plate
Chassis
Hook
Type "A" screw
Installation plate
D
C
Ø70mm
(Ø2.75inch)
Left rear piping
Installation
B
A
Ø70mm
(Ø2.75inch)
Right rear piping
Service Manual 17