Horizontal Installation - Heat Controller HBH/V Compact Installation, Operation & Maintenance Manual

IOM Instructions

Horizontal Installation

Figure 3: Typical Horizontal Unit Installation
Figure 3: Typical Horizontal Unit Installation
Supply Air
Insulated supply duct with
at least one 90 deg elbow
to reduce air noise
Air Coil
To obtain maximum performance, the air coil should be cleaned
before start-up. A 10% solution of dishwasher detergent and
water is recommended for both sides of the coil. A thorough
water rinse should follow. UV based anti-bacterial systems
may damage e-coated air coils.
Aire de alimentación
Conducto de alimentación
aislado con un codo (mínimo)
de 90 grados para reducir el
ruido del aire
HBH/V CompaCt
HORIZONTAL INSTALLATION
3/8" [10mm] threaded rods
(by others)
Power Wiring
Unit Power
Flexible Duct
Connector
Unit Power
Disconnect
(by others)
Unit Hanger
Varillas Roscadas de 3/8"
(fabricadas por terceros)
Retorno de
aire
Alimentación
de energía de
la unidad
Colgador
de la unidad
Disyuntor de
energía de la unidad
(fabricado por terceros)
Cableado de
alimentación
de energía
Return Air
Thermostat
Wiring
NOTICE! Installation Note - Ducted Return: Many horizontal
WSHPs are installed in a return air ceiling plenum application
(above ceiling). Vertical WSHPs are commonly installed in a
mechanical room with free return (e.g. louvered door). Therefore,
filter rails are the industry standard and are included on Heat
Controller, Inc., commercial heat pumps for the purposes of
holding the filter only. For ducted return applications, the filter rail
must be removed and replaced with a duct flange or filter rack.
Canvas or flexible connectors should also be used to minimize
vibration between the unit and ductwork.
Cableado
del termostato
Heat Controller, Inc.
Stainless steel braided hoses with
Stainless steel braid hose
threaded connections
with integral "J" swivel
and one swivel end
Optional Balancing Valve
Optional Low Pressure Drop Water
Control Valve
(can be internally mounted
on some models)
Water Out
Water In
Ball Valve with optional
integral P/T plug
Manguera trenzada de
acero inoxidable con accesorio
giratorio en "J"
Válvula compensadora opcional
Válvula invertida opcional para
control de baja presión de agua
(puede montarse en forma interna)
de edificación
Entrada de agua
Salida de agua
Válvula a bola con tapón
P/T integrado opcional
Building
Loop
Circuito