Remote Control Operation - Heat Controller DMH18DB-1 Service Manual

Operation

Remote Control Operation

The Remote Controller transmits the signals to the system.
5
6
4
2
7
ON
11
8
13
14
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
42 Multi type Air Conditioner
Signal transmitter
1
3
10
CANCEL
9
OFF SET
16
AUTO CLEAN
12
°C/°F
17
18
15
Flip-up door
(opened)
)
START/STOP BUTTON
1
Operation starts when this button is pressed and stops when
the button is pressed again.
OPERATION MODE SELECTION BUTTON
2
Used to select the operation mode.
ROOM TEMPERATURE
3
SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
4
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
5
Used to start or stop the speed cooling/heating.
(Speed cooling/heating operates super high fan speed.)
CHAOS SWING BUTTON
6
Used to stop or start louver movement and set the desired
up/down airflow direction.
ON/OFF TIMER BUTTONS
7
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
8
Used to adjust the time.
TIMER SET/CANCEL BUTTON
9
Used to set the timer when the desired time is obtained and to cancel
the Timer operation.
SLEEP MODE AUTO BUTTON
10
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
11
Used to circulate the room air without cooling or heating.
ROOM TEMPERATURE CHECKING BUTTON
12
Used to check the room temperature.
PLASMA(OPTIONAL)
13
Used to start or stop the plasma-purification function.
RESET BUTTON
14
Initialize remote controller.
2nd F Button
15
Used prior to using modes printed in blue at the bottom of buttons.
AUTO CLEAN
16
Used to set Auto Clean mode.
˚C TO ˚F SWITCHING BUTTON
17
Used to switch temperature reading from Centigrade to Fahrenheit.
HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (NOT ON
18
ALL MODELS)
Used to set the desired horizontal airflow direction.
(Cooling Only)
(Heat Pump)