Inventory - Grizzly G0747 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Small Item Inventory: (Figure 2)
A. Front Way Cover .......................................... 1
b. rear Way Cover .......................................... 1
C. drawbar ⁄ "-20 x 23
7
16
D. Ball handles ................................................ 3
E. Fine downfeed handwheel ......................... 1
F. Ball handle handles .................................... 3
G. toolbox ........................................................ 1
H. Bottle for oil ................................................ 1
I. Belt housing safety Covers (g0747 only) .. 2
J. Knee Crank ................................................. 1
K. Coarse downfeed lever .............................. 1
L. Closed-end Wrench 17 x 19mm.................. 1
M. phillips screwdriver #2 ................................ 1
N. slotted screwdriver #2 ................................ 1
Model G0747/G0748 (Mfg. Since 8/12)
Qty
⁄ " ............................... 1
1
2
A
C
e
d
h
i
J
n
M
Figure 2. small item inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
F
g
K
l
-17-