Q-See QS206 Quick Installation Manual page 3

PART 3 - CONNECTING THE DVR TO YOUR DISPLAY
To Connect to a Computer Monitor:
1. Plug the VGA cable (not included) to the VGA port on the DVR.
2. Connect the other end of the VGA cable to the monitor.
To Connect to a TV:
3. Plug the BNC to RCA adapter cable into the Video Out port on the DVR.
4. Connect the other end of the RCA cable to the Video Input on the TV.
NOTE! To switch back and forth between VGA and TV, use the
Mouse Scroll-Wheel: Forward-switch to VGA
Backward-switch to CVBS (TV).
VIDEO IN
1 2 3 4 5 6
DC +12V RJ45 USB
VGA
IN
ALM IN
1
2
IMPORTANT! The default resolution of this DVR is 1024x768 pixels. Some
monitors smaller than 19" may have problems displaying this resolution.
7 8 9 10 11 12 13 14
16 15
AUDIO IN AUDIO CVBS OUT
OUT
PART 4 - DVR CONTROLS: FRONT PANEL
Item # Name/ Symbol
1 STANDBY
2 MENU/EXIT
3 CHANNEL/
NUMBERS/
PLAYBACK
4 NAVIGATION/
OK
3
5 LED
INDICATORS
6 DURING
PLAYBACK
4
PRESS:
7 IR SENSOR
8
Description
Press to set the system in standby mode.
Press to open/close the main menu.
Press the number buttons to select a channel and view it full-
screen; press buttons 1-0 to input passwords and user IDs.
OK In menus, press to confirm selections; in PTZ mode,
press to change the navigation buttons to control a
connected PTZ camera (not included)
▲
Press to move cursor up; in PTZ mode, press to pan
camera up.
▼
Press to move cursor down; in PTZ mode, press to
pan camera down.
◄
Press to move cursor left; in PTZ mode, press to pan
camera left.
►
Press to move cursor right; in PTZ mode, press to
pan camera right.
Shows status of hard drive, recording, alarm, HDD full and
network.
◄ ◄
Increase reverse playback speed 1X, 2X, 4X.
/
Press to freeze playback to one frame, then press
►
n
again to advance frame-by-frame.
►
Press to start playback
► ► |
Press to slow playback speed by 1/2, 1/4, 1/8.
► ►
Press to increase forward playback speed 1X, 2X,
4X.
IR Receiver for remote control.
USB Connect a USB flash drive for data backup and
firmware upgrades