5: Pop-Ups & Activex Controls - Q-See QC-SERIES User Manual

to the same router as the DVR. This website will display your address as illustrated in Picture 16. The example
below shows an IP Address of 76.254.183.54. Please make sure to take note of the address that you obtain for your
own Router and use it accordingly.
(Picture 14)
5.2.3.5: Pop-Ups & ActiveX Controls
To access the DVR through Internet Explorer after you have configured your network settings on your DVR to match
the settings of your Router and forwarded your ports as discussed above, you will need to modify your browser
controls to allow Pop-ups. To do this, go to the Internet Explorer tool bar and select the "tools" option (RED box in
Picture 17), then select the "Pop up Blocker" option and select "Turn Off Pop-up Blocker" (BLUE arrows in Picture 17).
You will also need to enable Active X controls. To do this, go to the Internet Explorer tool bar and select the "tools"
option, then "Internet Options"(GREEN arrow in Picture 17). This will open an Internet Options dialog box as shown
in Picture 18. Through here, choose the "Security" tab (RED box in Picture 18), then click the "Custom Level" button
(GREEN box in Picture 18), then click on OK (BLUE arrow in Picture 18). This will open a dialog box as shown in
Picture 19. Once here, scroll down to the ActiveX Controls and Plug Ins and make sure they are all set to either
prompt (BLUE arrows Picture 19) or enabled (RED arrows Picture 19).
To connect to the DVR from the remote computer you would then open an Internet Explorer browser window and
enter the internet IP of your router that you got by going to www.myipaddress.com.
NOTE
: If you cannot use HTTP port 80 or 9000 because it is being used by another program, or it is being blocked by your service provider, you
can use another port in the same range. If you do so then you need to forward the IP address of the router to the other port, change the port in the
DVR NETWORK settings and you need to add the port number after the IP address. For example, if you set the HTTP port as 82, you need to enter
the IP address as 192.168.0.25:82.
User name and password here are the same as what you use on the DVR.
QSDR16RTCB User Manual
(Picture 15)
(Picture 17)
14
(Picture 16)