Chapter 3: Dvr Installation; Hard Drive Installation; Camera And Monitor Connection; Power Supply Connection - Q-See QSDR04RTC User Manual

3.1 Hard Drive Installation

Caution ： ： ： ： Please do not Install or take out hard drive when DVR is running!
(1) Remove screws and open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard drive securely;
(3) Put the upper cover back carefully, re-attach screws.

3.2 Camera and Monitor Connection

Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC
connector (Refer to section2.2-Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of DVR
respectively (refer to system figuration on Chapter 8).

3.3 Power Supply connection

Please only use the power adapter supplied with the DVR.

Chapter 3: DVR Installation

6
User Manual