Table of Contents
Advertisement
GETTING TO KNOW YOUR REMOTE CONTROL
PREPARATION
FOR USE
Batteries are providedwith this remote, but you must install
them before using the remote.
INSTALLING
BA'I-rERIES
When the effective operating range of your remote becomes
noticeably shorter, replace the batteries with two (2) high
quality, alkaline, size AAA batteries. Do the following steps:
1.
Remove
the battery
compartment
cover by PUSH-
ING DOWN
tab and PULLING
OUT from top.
2.
Insert
new batteries
as indicated
in the diagram
inside
the compartment.
Observe
proper
battery
polarity.
3.
Replace
the cover by inserting
the tab on the bot-
tom of the cover into its housing.
Snap the cover
into position.
4.
.i_fter installing
new batteries,
the remote
control
will set itself
to Zenith
brand
codes,
as follows:
TV = 101, VCR = 201 and CABLE
= 301.
If you are going
to operate
equipment
that
uses
different
codes, the remote must be reprogrammed
for
those
codes.
Refer
to "Programming
the
Remote
Control"
section
for programming
infor-
mation.
CAUTIONS:
•
Do not place heavy objects on top of the remote control
buttons. Prolonged
accidental
operation
of the remote
control will shorten battery life.
•
If you are not going to use the remote control for a month
or more, remove the batteries. Battery leakage can cause
damage to the remote control.
•
Zenith
is not responsible
for damage caused by such
battery leakage.
11
11
1
2._
5-5
Advertisement
Table of Contents
