Foxconn 760GXK8MB series User Manual page 41

vOnboard FDC Controller (Default: Enabled)
This option is used to set whether the onboard FDC controller is enabled.
vOnboard Serial Port 1/2 (Default: 3F8/IRQ4/2F8/IRQ3)
These options are used to assign the I/O address and interrupt request
(IRQ) for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
vUART Mode Select (Default: Normal)
Use this option to select the UART mode. Setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
vUR2 Duplex Mode (Default: Half)
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infared function of the onboard infrared
chip.
vOnboard Parallel Port (Default: 378/IRQ7)
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request(IRQ).
vParallel Port Mode (Default: SPP)
Select an address and corresponding interrupt request for the onboard paral
-lel port.
vECP Mode Use DMA (Default: 3)
Select a DMA channel for the parallel port when using the ECP mode.This field
is only configurable if Parallel Port Mode is set to ECP.
36
Onboard SuperIO Device Menu
Chapter 3 BIOS Description