Foxconn 760GXK8MB series User Manual page 23

1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected
to either the front (provided that the front panel
of your chassis is equipped with the appropri-
ate interface) or real panel of the chassis.
Wake-up On LAN: WOL
Through the Wake-Up On LAN function, a wake
event occurring from the network can wake up
the system. To utilize this function, please be
sure to use an ATX 12V power supply with a
5VSB line capable of delivering a current of at
least 1A, and a LAN adapter which supports
this function. Then connect the header to the
relevant connector on the LAN adapter, set
"MACPME Power Up Control" to "Enabled" in
the "Power Management Setup" section of the
CMOS SETUP. Save and exit, then boot the op-
erating system once to make sure this function
takes effect.
S-ATA Connectors:
(optional)
The S-ATA header is used to connect the S-
ATA device to the motherboard.
These connectors support the thin Serial ATA
cables for primary internal storage devices.
The current S-ATA interface allows up to
150MB/s data transfer rate.
18
Chapter 2 Installation Instructions
SATA-1, SATA-2
Empty
GND
12V
12V
TPB -
TPB +
GND
GND
TPA - TPA +
1
F_1394
Signal for waking up
GND
1
+5VSB
WOL
GND
1
TX+
TX-
GND
RX-
RX+
GND
SATA_1/SATA_2