Extreme Networks Altitude 4700 Series Product Reference Manual page 195

Creating a LAN IP Filter Policy.
admin(network.lan.ipfpolicy)>add 1 icmp1 incoming deny
admin(network.lan.ipfpolicy)>show 1
------------------------------------------------------------------
Idx Filter-Name
------------------------------------------------------------------
1 icmp1
IP Filter Mode
Default Incoming Action
Default Outgoing Action
admin(network.lan.ipfpolicy)>
NOTE
For information on applying a filter to a WLAN or LAN using the Access Point GUI applet, see,
Filter to LAN1, LAN2 or a WLAN (1-16)" on page
Assessing IP Filter Stats
Detailed IP filter statistics can be displayed as follows from the Access Point CLI:
admin(stats)>show s-wlan 1
Name
ESSID
Authentication
Encryption
Radio/s
Number of Associated Clients
Traffic Information:
Packets per second:
Rx : 0 pps
Tx
Total
<Hit any key to continue>
Throughput:
Rx
Tx
Total
Average Bit Speed
%Non-Unicast Packets
RF Status:
Avg MU Signal
Avg MU Noise
Avg MU Signal-to-Noise
Error Information:
Average Number of Retries
Altitude 4700 Series Access Point Product Reference Guide
The following example uses the Access Point CLI:
Direction Action
incoming deny
: enable
: deny
: deny
191.
: joe
: joe
: No Authentication
: No Encryption
: 802.11a, 802.11b/g
: 1
: 0 pps
: 0 pps
: 0.00 Mbps
: 0.00 Mbps
: 0.00 Mbps
: 0.00 Mbps
: 0.00 %
: 0.0 dBm
: 0.0 dBm
: 0.0 dB
: 0.00 Retries
"Applying a
195