Configure Vr Add Protocol - Extreme Networks ExtremeWare XOS Command Reference Manual

configure vr add protocol

configure vr <vr-name> add protocol <protocol-name>
Description
Starts the layer 3 protocol on a virtual router.
Syntax Description
vr-name
protocol-name
Default
N/A.
Usage Guidelines
When a new virtual router is created, by default, no ports are assigned, no VLAN interface is created,
and no support for any routing protocols is added. Use this command to start the layer 3 protocol
specified on the virtual router. The choices for
• RIP
• OSPF
• BGP
• PIM
You cannot add or delete protocols from the system virtual routers, VR-Mgmt, VR-Control, VR-Default.
Example
The following command starts RIP on the virtual router vr-acme:
configure vr vr-acme add protocol rip
History
This command was first available in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies the name of the virtual router.
Specifies the layer 3 protocol.
protocol-name
configure vr add protocol
are:
265