Extreme Networks ExtremeWare XOS Command Reference Manual page 1915

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
install firmware
Installing active bootrom
Installing system FPGA image
Installing bootstrap
Installing active bootrom
Installing system FPGA image
MSM bootrom(s) installed successfully
MSM bootrom(s) will be activated upon next MSM reboot
Installing bootrom...
Installing microcontroller firmware to slot 1 ...
Installing FGPA firmware to slot 1. This will take a few minutes...
Installing microcontroller firmware to slot 2 ...
Installing FGPA firmware to slot 2. This will take a few minutes...
Installing microcontroller firmware to slot 5 ...
Installing FGPA firmware to slot 5. This will take a few minutes...
Installing microcontroller firmware to slot 6 ...
Installing FGPA firmware to slot 6. This will take a few minutes...
IO module bootrom(s) installed successfully
IO module bootrom(s) will be activated upon next IO module reboot
Installing firmware...
PSU controller firmware installed successfully
EXOS may take up to 10 seconds to recognise that a new PSU firmware image has been
installed
Micro controller image on local MSM also needs update. This requires primary MSM to
update backup MSM.
Make this MSM as a backup and run this command on the new primary.
Additional Behavior—BlackDiamond 8800 Series Switch Only. During a firmware upgrade, the switch
prompts you to save your configuration changes to the current, active configuration. Enter to save
y
your configuration changes to the current, active configuration. Enter if you do not want to save your
n
changes.
In earlier versions of ExtremeWare XOS, you are required to immediately reboot the system after a
firmware upgrade. In ExtremeWare XOS 11.3.3 and later, the system displays a message informing you
that the new firmware image will be activated the next time you reboot the system.
Use the command to configure how
configure firmware [auto-install | install-on-demand]
the switch performs a system firmware upgrade. If you select the parameter, you are not
auto-install
prompted to confirm the firmware upgrade. If you use the default configuration ,
install-on-demand
you can cancel the firmware upgrade.
Power over Ethernet (PoE) firmware is always automatically upgraded or downgraded to match the
operational code image. This configuration is not applicable to PoE firmware.
Additional Behavior—BlackDiamond 12804 Switch Only. To install the new BootROM and firmware, wait
until the command indicates the MSMs and I/O modules are operational. When the
show slot
modules are operational, use the command to install the BootROM and/or
install firmware
firmware only on modules that have older BootROM or firmware images installed.
1915
ExtremeWare XOS 11.5 Command Reference Guide