Advertisement
W!_f_Y/'-_I ;]OIIO[_
Beforeinspecting;cleaningor servicingthe machine;shutoff engine, wait lor all moving parts to come to
I
a completestop; disconnectspark plug wire and move wire away lrom spark plug
ttt(
I Failure to lollowthese instructionscan result in serious personal inju_ or propertydamagei
t
z_J
I
(E) Remove belt
NOTE:While pushing inward on the
&Replace
the forward drive belt in the
Reverse Drive Belt:
High speedgroove (groove closest to
Removethe belt cover after first shutt
engine) orthe Low s peedg roove(rear;
ting off the engine; disconnecting the
most) groove of the engine drive pulley
spark plug wire, and allowing the engine
and in the matching groove of the transi
and muffler to cool down.
mission pulley. Besure the belt is to the
2: stand at the front of the tiller and use
inside
of the wire formed beltguide (I
your left hand to push the reverseidler
Figure
5i12)and to the inside of the
arm (Ki Figure5it3)inward as fai asposi
forward drive idler pulley (J);siNe
(the reverse idler pulley [L] is
attached to the reverse idler arm):
Holdthe idler arm in this position and look
Figure5.10:One or twothreads on Forward
at
the position of the belt tensionguide
ClutchRod should be
exposed
aboverectan-
mark (M, Figure 5-t4)that is stamped into
gularnut,
the face of the reverse adjustable link (N,
Figure5-14).
*
The tension is correct if the quide mark
(M, Figure5-14) is anywhere to the left of
the guide pin (O)i as Viewedfrom the
Figure5-12: Top view of belts andpulleysi
9, Reinstall the belt cover and secure it
with the two nuts.
10.
Readjustthe forward d rivebelt tension
byfollowing the instructions in Section 3:
HandlebarHeight Adjustment.
Figure5"11_Remove clevis pinfrom
_
idl
goes,
:
epus geerseoe
holeinforward adjustable linkandmoveto
arminwardstand at enoine endand
'
check position ofguide mark(M)and
guide pin(O)i
Advertisement
