Table of Contents
Advertisement
15. Current playback time (the time indicated by the slider)
16. End time for time bar (the right-most point of the time bar)
3.6 PTZ
3.6.1
General PTZ control
Right-click to bring up the menu bar and click on
The following actions can be performed using the PTZ Menu:
1. Use Direction Arrows (up, down, left, right) to move the camera to the desired direction
and angle.
2. To Zoom, Click "Z+" to zoom closer or "Z-" to zoom farther away.
3. To Focus, click "F+" to focus far or click "F-" to focus near.
4. With Iris, you can increase the amount of light by clicking "I+" or decrease it by clicking "I-".
5. To program a preset position (if supported by the camera)
a. Move PTZ camera to the specified position
b. Click "Preset" button
c. Click the number of the desired position (This will be displayed in the box)
d. Click "Set" button
6. To jump to a preset position
a. Click "Preset" button
b. Click the number of the desired position
c. Click "Go" button
7. Shortcut for presets #1-9
a. Click digit 1-9 button without clicking any other buttons
b. The camera will seek that preset position
8. Steps to delete a preset position (if supported by the camera)
a. Click "Preset" button
b. Click the number of the desired position
c. Click "Delete" button
9. For Auto Pan
a. Click "Auto Pan" button
10. Pattern Operation (Pattern is the "0" Tour in Everfocus and Pelco PTZ cameras)
a. Click "Pattern" button
11. Steps to run a tour
a. Click "Tour" button
b. Click the number of the desired tour
c. Click "Go" button
(if PTZ cameras are installed)
to display PTZ Controls.
26
Advertisement
Table of Contents
