Table of Contents
Advertisement
NOTE: To perform a Firmware Upgrade, you will need to connect a USB flash device with
the desired firmware. Do not disconnect the USB device or turn off the power to the
unit during the upgrade; this can cause the system to fail to recover, requiring factory
service to repair.
Configurations
Load Factory Default: Click "Load" to restore all menu settings to the default values. User Account,
Network IP Settings, and Time are not affected. 3GP streaming is disabled by default.
Load From USB: Click "Load" to upload saved DVR configuration settings from a USB flash device.
Save To USB: Click "'Save" to save the current DVR configuration settings to a USB flash device.
Language: Choose which language the DVR uses. The available languages may vary based on region.
Allowed Remote Reboot: Users can enable a remote command to reboot the DVR via the web interface.
The "Reboot Now" button which reboots the DVR is located only in the web interface System Menu at the
top of the "Misc." screen.
4.10.6
Quick Archive
Archive Interval: At the DVR, press and hold the Copy button from the front panel to copy the previous 10
(or 20, 30,60, 90) minutes of video prior to the current time for all cameras. Leave a blank DVD in the drive
in case of events/emergencies. At the DVR, press and hold the COPY key; a beep will sound and the
process begins; DVR will beep again on completion and DVD ejects. Give the DVD to the authorities when
it ejects (DVR automatically copies player software onto media as well). Copies to USB (if present) first,
Figure 4-43 System Menu – Quick Archive
96
Advertisement
Table of Contents
