Adjusting The Motion Control Levers; Positioning The Seat; Pushing The Machine By Hand - Toro TimeCutter Z4200 Operator's Manual

Adjusting the Motion Control
Levers
4-1/2 in (115 mm)
4 in (102 mm)
3-1/2 in (89 mm)
3 in (76 mm)
2-1/2 in (64 mm)
2 in ( 51 mm)
1-1/2 in (38 mm)
;7 ,: . ..... '-...........
1. Height-of-cut lever
G005312
Figure 14
2. Height-of-cut positions
2. To adjust the height of cut, pull inward and up on
the lever and move it to the desired position.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment M_ob just
enough that seat can move (Figure 15).
1
\
G005061
1. Adjustment knob
Figure 15
2. Move the seat to the desired position and tighten
the kmob.
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 16).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 16).
2
G005062
Figure 16
1. Control arm shaft 3. Slotted, upper hole
2. Control lever 4. Bolt
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to
the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft (Figure 16). Tighten both
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by Hand
Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
17