4
2
3
1
G000538
Figure 30
1.
Positive battery post
3.
Red (+) charger lead
2.
Negative battery post
4.
Black (-) charger lead
Note:
Do not run the machine
with the battery
disconnected,
electrical
damage
may occur.
Installing the Battery
1. Position the battery in the tray with the terminal
posts toward the operating position (Figure 29).
2. Install the positive (red) battery cable to the positive
(+) battery terminal using the fasteners removed
previousl 7
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previousl 7
4.
Slide the red terminal
boot
onto the positive
(red)
battery
post.
5. Secure the battery with the hold-down
(Figure 29).
6.
Install
the left side console.
Refer to the Accessing
the Battery
procedure
in Premaintenance
Procedures
, page 21for instructions.
1.
G005073
Main-30 amp
1
2
Figure 31
2.
Charge circuit-25 amp
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance;
however, if a fuse blows, check the
component/circuit
for a malfunction
or short.
Fuse:
•
Main FI-30 amp, blade-type
•
Charge Circuit F2-25 amp, blade-type
1. Raise the seat to gain access to the fuse holder
(Figure 31).
2. To replace a fuse, pull out on the fuse to remove it
(Figure 31).
28