EverFocus ECOR264-4D2 User Manual page 114

number of the IP address. For example, if the IP address of the computer is 192.168.2.101, the
DVR's IP address should be 192.168.002.050.
 To access the DVR from a computer simply open Internet Explorer and in the address bar type:
http:// (IP address of the DVR)
Note: The DVR's IP address will only work at the location of the DVR. To connect from a

different location over the Internet, see below.
To set DVR for Internet Connection through router
 The next step is to open ports within your router. Log into the router using a PC and open the
following ports.
o Ports to open: 80
o If your Internet service provider blocks port 80, you can change it to a different port in the
DVR's Network Menu Setup; open/forward that port instead.
o If you are using a Linksys or D-Link router, see Chapter 8 for basic support on setting up
ports. For any other router, you will need to contact the manufacturer for support.
 To access the DVR from a computer simply open Internet Explorer and in the address bar type:
http:// (the IP address given by your internet service provider)
Note: If you changed to a different port other than 80, you will need to include this at the

end of the IP address
http:// (the IP address given by your internet service provider):portnumber
 If you have a WAN Dynamic IP address and have opened the ports, go to Chapter 7 to setup
DDNS.
106