Advertisement
On
operating
voltage
Befme operating
the system, check that the operating
voltage
of yore system
is identical
with tile voltage
of
your local power supply.
On
safety
• The unit is not disconnected
fiom the AC powm
source (mains)
as long as it is connected
to the wall
outlet, even if the unit itself ha s been turned off
• Unplug
tlle system
fiom the wall outlet 0nains)
if it
is not to be used for an extended
period of time. To
disconnect
the power cord 0nains lead), ptfll it out by
the phlg. Never pull the cord itself.
• Should any solid object or liquid fall into the system,
unplug
the system
and have it checked
by qualified
personnel
before operating
it any fiuther.
• AC power cord must be changed
only at the qualified
service shop
On
placement
• Do not place the system in an inclined
position.
• Do not place the system in locations
where it is
Extremely
hot or cold
Dusty or dirty
Va T Nnnid
Subject to vibrations
Subject to direct sunlight
• Use cantion
when placing
the trait or speakms
on
surthces
that have been specially
neared (with wax
oil, polish, etc.) as staining
or discoloration
of the
surface may result
On
heat
buildup
• Although
the system heats up during operation,
this
is not a malfimction.
• Place the system in a location
with adequate
ventilation
to prevent heat buil&_p in the systmn.
• Ifyml continuously
use this system at a high volmne,
the cabinet temperatme
of the top, side and bottom
rises considerably.
To avoid burning
yourselt\
do not
touch the cabinet.
• To p;event
a malfunction,
do not corm
the
ventilation
tmle for the cooling thn
On the
speaker
system
This speakm
system is not nmgnetically
shielded
and
the picture
on TV sets *nay become
mamletically
distorted.
In such a case, turn off the power of the TV
set once
and after 15 to 30 nfinutes
tmn it on again.
If there seems
to be no improvement,
locate the
speaker
system further away from the TV set
On operation
• It'the system
is brought
directly
from a cold to a
wmm location,
or is placed in a ve*y damp room,
moisture may condense
on the lens inside the CD
player
Should this occur, the system will not operate
properly.
Remove
the disc and leave the system
lmned on tbr about an hour tmtil the moisture
evaporates
• Wqlen you move the system, take out any disc.
If you have any questions
or problems
concerning
your
system, please consult your nearest Sony dealer.
Notes
on
discs
• Befole playing
clean the disc with a cleaning
cloth.
Wipe the disc flora the center out
• Do not use solvents
such as be,_zine, thinner,
commelcially
available
cleanels
or anti-static
spray
intended
for vinyl LPs.
• Do not expose tlle disc to direct sunlight
or heat
somces
such as hot air ducts, nor leave it in a car
parked
in direct sunlight
• When using discs that have glue or similar
tacky
substance
on the label side of the disc or that used a
special ink when the label was printed,
there is a
chance that the disc or label may become
attached to
parts inside this trait When this occurs, it may not be
possible
to remove
the disc, and may also canse this
unit to malfimction.
Be sure to check that the label
side of the disc is not stick?, before
using.
The tbllowing
types of disc should not be used:
Rental
or used discs with attached
seals whele the
glue extends beyond
the seal The perimeter
of the
seal on the disc is tacky.
Discs tha* have labels printed using a special
ink
that feels tacky when touched.
• Discs with non-standard
shapes (e.g., hea*t, square,
star) cannot be played on this unit. Attempting
to do
so may damage
the unit Do not use such discs.
e,
8"
o
continued
37Gs
Advertisement
