Table of Contents
Advertisement
What cordswill I need?
Audio/video/S-link
connecting
cord (supplied)
(1)
Yellow
_
_
Yellow
White (L)
White (L)
Red (R)
Red (R)
S-link
S-link
Hookups
When connecting the cords, be sure to match the color-
coded cord to the appropriate
jacks on the components:
Yellow (video) to Yellow, Red (right) to Red and White
(left) to White. Be sure to make connections
firmly to
avoid hum and noise.
IITo listen to the sound through TV speakers
TV
CD/DVD player
iNPUT
_'-
AUDIO
IITo listen to the soundthrough speakersconnected to
an amplifier
CD/DVD player
I
R-AUDIO 1-.L
VIDEO 11
®®®1
t:14tU
IOlb.L
ill)E021
L NEOUT
I
,_.x,,.
"IV
INPUT
_
VIDEO
lOlL
t'_
AUDIO
((O_IR
Amplifier
Notes
• Do not connect this
player to a video deck.
If you view the pictures
on your TV after
making the connections
shown on the right, a
picture noise may
appear.
I
VCR
I
CD/DVD
[
Connect
Player
directly
Depending
on the TV or amplifier,
sound distortion may
occur because the audio output level is high. In this case,
set "AUDIO
ATr" in "INITIAL
SETUP 2" to "ON" in the
setup display.
For details, see page 35.
"_°
If your TV has an S video input connector
Connect the component
via the S VIDEO OUT connector
using the S video cable (supplied)
instead of the video
connecting
cord. You will get a better picture.
S video cable (supplied)
CD/DVD player
TV
"_°lf
you connectthe player to a monitor or projector
with component video input connectorsthat conform
to output signalsfrom the COMPONENTVIDEO OUT
(Y, CriB-Y, CdR-Y) connectors on the player
Connect the component via the COMPONENT VIDEO
OUT connectors using three video connecting cords (not
supplied) of the same kind. You will get a better picture.
Note
Refer to the instructions
supplied
with the,component
to be
connected.
(Continued)
7 EN
Advertisement
Table of Contents
