Snapper NSXPV2270E Operator's Manual page 9

Unpack the
1.
2,
3.
Mower
Cut all four corners of the box from top to bottom.
Remove aii packing materials from the mower.
Locate and identify the items included with the mower:
• Mulching plug (A, Figure 1 - installed)
• Grass bag (B)
• Battery charger (C - SPXV2270E, NSPXV2270E)
• Side discharge deflector (D)
• Operator's manual (E)
Assembly
d
Figure2: Raisingthehandle assembly
Figure1: Items included
Raise the HandleAssembly
1. Loosen, but do not remove, the knobs (A, Figure 2) on
both sides of the upper handle.
2. Unfold the upper handle so that it is aligned with the
lower handle, and tighten the upper knobs.
3. Remove the handle knobs, washers and carriage bolts
from the lower handle (B).
4. Raise the lower handle, aligning it with one of the three
sets of holes in the handle bracket. (Most users will pre-
fer the middle position). Replace the hardware removed
in Step 3, tightening securely.
Set Up the Starter Rope Handle
1. Squeezethe blade control (A, Figure 3) against the
drive control (B).
NOTE. The blade control and drive control can be operated
from either side.
2. Pull the starter rope handle (C) out of the engine to the
rope guide (D). Hook the starter rope into the rope guide
(it might be a tight fit).
Figure3. Starter ropehandle