Download Print this page

Sharp Carousel R-405D Operation Manual page 5

Advertisement

Unpackingand ExaminingYour Oven
Remove:
t, all packing materials from inside the oven cavity;
however,
DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the right cavity wall
Read enclosures
and SAVE
#_
_eaIFng surfaces
Waveguiae
Hin[_es
_
cover
broken or loose door hinges
and latches and dents inside the cavity or on the door,
If there is any damage, do not operate the oven and
contact
your
dealer
or SHARP
AUTHORIZED
SERVICER.
the Operation Manual.
2. the feature sticker, if there
is one, from the outside of the
door,
Check the oven for any dam-
age, such as misaligned
or
beat
door,
damaged
door
seals and sealing surfaces,
Choosinga Location for Your Oven
You will use the oven frequently so plan its location for
ease of use, It's wise, if possible, to have counter space
on at least one side of the oven+ Allow at least 2 inches
on the sides, top and at the rear of the oven for air
circulation, Do not place or install the oven in any area
where heat and steam are generated;
for example,
next to or above a conventional
gas or electric range
or above a conventional
walt oven
Heat and steam
may damage the electronics orthe mechanical parts of
the oven,
Built-in Kit
Your oven can be built into a cabinet
or wall--not
near or above a heat source--using
Sharp's Built-in Kit
RK+51 for the R+508DK; the RK-46K for the R-405DK
and the RK-46W for the R-408DW. If your dealer does
not stock the kit, it can be ordered directly from the St_arp
Accessories
and Supplies
Center,. Have your credit
card number available and call toll-free: 1-800-642-2122
for ordering the kit to be sent to your address
The kit includes ducts and finish trim strips and easy-
to-follow
instructions
for installation
as welt as the
location of the power supply.
This appliance must be grounded+ This oven is equipped with a cord having a grounding wire with a grounding plug,
It must be plugged into a wall receptacle that is properly installed and grounded in accordance
with the National
Electrical Code and local codes and ordinances
In the event of an electrical short circuit, grounding reduces risk of
electric shock by providing an escape wire for the electric current+
WARNnNG
- improper use of the grounding plug can result in a risk of electric shock,
Electrical Requirements
The electrical requirements are a 120 voit 60 Hz, AC only, 15 amp
or more
protected electrical supply
It is recommended
that a separate circuit serving
Permanent and Correct tnstattation
only this appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a
wal! receptacle that is properly installed and grounded.. Should you only have a
2-prong outlet, have a qualified electrician install a correct walt receptacle..
A 3-prong adapter may be purchased and used temporarily if local codes allow.
Follow package directions.
A short power-supply
cord is provided to reduce risk of becoming entangled in
or tripping over a longer cord.
Extension
Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that
has a 3+blade grounding plug and a 3-slot receptacle that will accept the plug on
Temporary Use
the microwave oven. The marked rating of the extension cord shoutd be ACt 15-
6round
!20 volt, 15 amp or more
Grounding
Receptacte
Box
Adapter
Be careful not to drape the cord over the countertop or table where it can be
,..__
pulled on by chiidren or tripped over accidentally.
Notes:
1 if you have any questions
about the grounding
or electrical instructions,
Scr
consult a qualified electrician or service person.
Tabfer
_
L_
I_
2 Neither Sharp nor the dealer can accept any liability for damage to the oven
Grounding Screw
or personal injury resulting from failure to observe
the correct electrical
connection procedures
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and
signal of receiving antenna.
3-Prong Plug
::22'::::++°
Ground
Receptacle
Box

Advertisement

loading

This manual is also suitable for:

Carousel r-508dCarousel r-408d