Table of Contents
Advertisement
Storinq Channels in Memorv_(Automatie Method!
1,
Press the MENU button to display the menu.
Press the A or T button to select "Channel", then press the ENTER _
button.
2,
Press the A or V button to select "Auto Program", then press the ENTER _
button.
3=
Press the A or T button to select the antenna connection, then press the
ENTER _
button.
>-Air: "Air" antenna signal.
Cable: "Cable" antenna signal.
Auto: "Air" and "Cable" antenna signals.
4=
When selecting the Cable TV system:
Press the ENTER _
button to start the auto program.
Press the 4 or I_ button, then press the A or T to select the correct analog signal
cable system source among "STD", "HRC", and "IRC". Press the ENTER _
button.
If you have Digital cable TV, select the cable system signal source for both Analog
and Digital.
:_ STD, HRC and IRC identify various types of cable TV systems. Contact your
local cable company to identify the type of cable system that exists in your
particular area. At this point the signal source has been selected.
The TV begins memorizing all available stations.
After all the available channels are stored, it start to remove scrambled
channels(see page 28).
> If you want to stop Auto Programming, press the ENTER _
button. The "Stop
Auto Program?" message will be displayed. Select "Yes" by pressing the *,i or
button, then press the ENTER _
button.
Press the EXIT button to exit.
Advertisement
Table of Contents
