Table of Contents
Advertisement
Operation
Turning the TV On and Off
Press the POWER_b button on the remote control.
You can also use the POWER_
button on the TV.
POWER
SOURCE
Plug & Play Feature
When the TV is initially powered on, basic settings proceed automatically and
subsequently.
Press the POWER(b button on the remote control.
The message "Menu Language, Store Demo, Channels and Time will be set." is
displayed.
Press the ENTER _
button, then "Select the language of the OSD" menu
is automatically displayed.
2_
3_
Press the A or T button to select language, then press the ENTER _
button.
The message "Select 'Home Use' when installing this TV in your home." is
displayed.
Press the _ or _ button to select "Store Demo" or "Home Use", then
press the ENTER _ button.
The message "Select the antennas to memorize." is displayed.
>_ We recommend setting the TV to "Home Use" mode for the best picture in your
home environment.
>_ "Store Demo" mode is only intended for use in retail environments.
>_ If the unit is accidentally set to "Store Demo" mode and you want to return to
"Home Use" (Standard): Press the Volume button on the TV. When the volume
OSD is displayed, press and hold the MENU button on the TV for 5 seconds.
4_
Press the A or T button to memorize the channels of the selected connection.
Press the ENTER _
button to select "Start".
>-Air: "Air" antenna signal.
Cable: "Cable" antenna signal.
Auto: "Air" and "Cable" antenna signals.
>_ In Cable mode, you can select the correct signal source among STD, HRC, and
IRC by pressing the A, T, _ or I_ button, then press the ENTER I:_ button.
If you have Digital cable, select the cable system signal source for both Analog
and Digital. Contact your local cable company to identify the type of cable
system that exists in your particular area.
5_
The TV will begin memorizing all of the available channels.
>- To stop the search before it has finished, press the ENTER _ button with "Stop"
selected.
>-After all the available channels are stored, it starts to remove scrambled
channels (see page 28). The Auto program menu then reappears.
Press the ENTER _
button when channel memorization is complete. The
message "Set the Clock Mode." is displayed.
Advertisement
Table of Contents
