RRP 10.5 EEPROM Board (PL 10.1.16)
1
Removal
1.
Remove the Left Side Cover (RRP 1.6).
Caution: The yellow and gray harnesses on the EEPROM Board
(item #1) contain the same number of pins, but are NOT
interchangeable. Make sure P/J144 (yellow) is connected
on the top and the P/J145 (gray) is connected to the
bottom.
2.
Disconnect P/J144 and P/J145 from the EEPROM Board on the left side of the
printer.
3.
Remove 1 screw securing the EEPROM Board and remove the board.
Note:
When a new EEPROM Board is installed in the printer, the
CRUM data written to the EEPROM makes it unique to that
printer. The EEPROM board cannot be re-used in another
printer
210
Phaser 6200 Color Laser Printer - Service Manual
P/J 144
P/J 145
S6200-158