Operating Chain Saw; Oiling Chain; Clearing Sprocket Cover Of Debris - Remington M30016AW Owner's Manual

OPERATING CHAIN SAW
.¢k
_J_ WARNING: Read and understand
this owner's manual before operat-
ing this saw. Make certain you read
and understand all important Safety
Information. Improper use of this
chain saw can cause severe injury
or death from fire, electrical shock,
or body contact with moving chain,
or falling wood.
FILLING OIL TANK
1 Removeoil cap.
2 Fill oil tank with SAE #30 motor oil Note:
For temperatures below 30_F, use SAE #10
oil, For temperatures above 75°F, use SAE
CklOoil
DO NOT use standard bar and chah'_ oil
3. Replace oil cap at once Tighten oil cap firmly
for good seal "t'his wil! avoid oil seepage from
cap
4. Wipe off excess oil..
not In use.. It is necessary to empty oll
nk after each use to prevent seepage_
OILING CHAIN
Manual Oil System
Always check oil level before using saw Do not
attempt to operate tile oil system while saw is
in operation,. To oil chain, press squeeze bulb
Oil will feed onto the guide bar and chain Press
squeeze bulb at least once belbre each cut Check
oil level oiien by looking at oil level through side
of oil bottle (see Figure 9)
Oil Squeeze Bulb
/
Oil _3ottle
CLEARING SPROCKET COVER OF
DEBRIS
While operating the chain saw, wood chips, small
twigs, and other debris ctm occasionally build up
inside the sprocket cover re properly maintain the
saw and keep it in good v, orking order, periodic
rome',el of this debris may be required To prop-
erly clear debris from the sprocket cover:
1, Unplug chain saw
2 Loosen and remove guide bar nut (see Figure
I0)
3, Turn chain tensioning screw counterclockwise
to loosen chain until sprocket cover is easily
removed
4 After sprocket cover is remo'.ed, clear till
chips, twigs, and debris
WARNING: Use caution when
clearing debris that is around chain.
Cutting edges on chain are sharp.
Use protective gloves when working
around or handling chain.
Once debris has been removed, follow steps 7
tl_rough t 3 on pages 9 and 10 in the A ssembty
section to re-assemble the sprocket cover to
the chain sa_,
WoodChips,
Twigs and Debris
/
\
Sprocket Cover
./
/
//
Guide Bar Nut
Figure !0 - Removing and Clearing Sprocket
Cover of Debris
Figure 9 - Oil Squeeze Bulb and Oil Bottle
Location
13
wwy_rotrthlg_ctopow_rrools, corlt