Remington M30016AW Owner's Manual page 11

ASSEMBLY
Pull the guide bar away from the saw body
so that the guide bar is fully extended and the
slack i'_removed from the chain (See Figure
6)
10 Finger tighten the guide bar nut onto the guide
bar bolt (See Figure 81
Figure 6 - Pulling Guide Bar
Insert the sprocket cover tab into the saw body
tab slot, Step 1 Then lower sprocket cover
onto guide bar bolt, 5uT 2 [See Figure 7)
NOTE: At this point tile sprockel cover will
no___J be flush against the saw body
J
....... Guide
Bar Nut
Figure 8 - Guide Bar Belt
t 1. Slowly slide guide bar into saw body until the
adjustment block goes into 1.11o round adjusting
hole on the guide bar (See Figure 6) NOTE:
This locks the guide bar in place You should
not be able to push or pull the guide bar
I2 Retighten the b.'tr nut linger tight.
13. Adjust the saw chain lension Follow the steps
under Sm_ Chait, Tett_ion Adju_tttl_nt
\
Tab Slot SprocketCoverTab
J:i
Sprocket Cover Tab
Figure 7 - Installing Sprocket Cover
11 www,mmlngtonpowerf_olscorn