Epson Aculaser M2000 series User Manual page 84

3. Remove the developer unit containing the toner cartridge.
4. Put your finger into the hole of the outer green knob on each side of the photoconductor unit.
Then, pull the photoconductor unit towards you.
Warning:
w
Be careful not to touch the fuser, which is marked CAUTION HOT SURFACE, or the
surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very
hot. If you must touch one of these areas, wait 30 minutes to allow the heat to subside before doing
so.
Troubleshooting 84