Removing Paper Jams; Misfeed Jams - NEC 4400 - SuperScript Color Laser Printer User Manual

R P
EMOVING APER
• To avoid damage to rollers, always remove jammed
paper gently.
• Try to remove jammed paper without tearing it. Any
pieces of media left in the printer, whether large or small,
can obstruct the paper path and cause further jams.
If, after clearing the paper jam, the jam message on the
Operator Panel persists, open and close the Top Cover. This
should clear the jam message.
If Jam Recovery is enabled (see page 55), once the jammed
paper is removed and the printer is online, the printer should
resume printing the job from the page where the jam
occurred.
106 SuperScript 4400 Series — User's Guide
J
AMS

Misfeed Jams

Misfeed jams happen in Paper Tray 1 or 2. A misfeed jam
may be as simple as a sheet of media not being picked up, or
it may be that the paper was picked up but not fed properly.
Access to this area is through the tray slot.
1. Remove the paper tray.
2. Pull out the jammed media.
3. Make sure the paper is lying flat in the tray and that the
stack does not exceed the media limit mark inside the
tray.
4. Slide the tray back into the printer.