Defining Protocol Ports Using CLI Commands
The following table summarizes the equivalent CLI command for defining Protocol Ports.
Table 7-65. Protocol Port CLI Commands
CLI Command
switchport general map
protocols-group group
vlan vlan-id
The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8:
console (config-if)# switchport general map protocols-group 1 vlan 8
Configuring GVRP
GARP VLAN Registration Protocol (GVRP) is specifically provided for automatic distribution of
VLAN membership information among VLAN-aware bridges. GVRP allows VLAN-aware bridges to
automatically learn VLANs to bridge ports mapping, without having to individually configure each
bridge and register VLAN membership.
The GVRP Global Parameters page enables GVRP globally. GVRP can also be enabled on a per-
interface basis. To open the GVRP Global Parameters page, click Switch→ VLAN→ GVRP
Parameters in the tree view.
Figure 7-102. GVRP Global Parameters
234
Configuring Switch Module Information
Description
Sets a protocol-based classification rule.