Defining Traps - Dell PowerConnect 5316M User Manual

The following is an example of the CLI commands:
console(config)# snmp-server community public_1 su 1.1.1.1
console(config)# snmp-server community public_2 rw 2.2.2.2
console(config)# snmp-server community public_3 ro 3.3.3.3
console(config)# snmp-server host 1.1.1.1 public_1 1
console(config)# snmp-server host 2.2.2.2 public_2 2
console(config)# end
console# show snmp
Community-String
-------------------------------------
public_1
public_2
public_3
Traps are enabled.
Authentication-failure trap is enabled.
Trap-Rec-Address
-----------------
1.1.1.1
2.2.2.2
System Contact: 345 6789
System Location: 1234 5678
console#

Defining Traps

From the SNMP Trap Settings page, the user can enable or disable the switch module to send
SNMP traps or notifications. To open the SNMP Trap Settings page, click System → SNMP→
Traps in the tree view.
154
Configuring System Information
Community-Access
super
readwrite
readonly
Trap-Rec-Community
-------------------
public_1
public_2
IP address
1.1.1.1
2.2.2.2
3.3.3.3
Version
---------
1
2