Zanussi ZKG 2105 User Manual page 27

Water inlet
Caution!
• This appliance must be connected to a
cold water supply
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection
to the machine. Do not place the inlet hose
downwards. Angle the hose to the left or right
depending on the position of your water tap.
Set the hose correctly by loosening the ring
nut.
www.zanussi.com
If necessary, check
the setting with a spi-
rit level.
45°
Connect the hose to
a tap with a 3/4"
thread.
• After positioning the inlet hose, be sure to
tighten the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside di-
ameter of the drain hose. The drain hose must
not be kinked.
Hooked over the
edge of a sink us-
ing the plastic
hose guide.
27