Zanussi ZKG 2105 User Manual page 21

Make sure that the impeller of the pump can
turn. If this does not occur, contact the service
centre.
2
Clean the filter under the water tap and put it
back in the pump into the special guides.
Make sure that you tighten correctly the filter
to prevent leakages.
Close the pump door.
Caution! When the appliance is in use
and depending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during a wash
cycle, always wait until the appliance has
finished the cycle, and is empty. When refitting
the pump cover, ensure it is securely re-
tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes
long to fill with water, the starting button blinks
www.zanussi.com
1
yellow or the display (if available) shows the
relevant alarm (see chapter "What to do if..." for
more details), check if the water inlet filters are
blocked .
To clean the water inlet filters:
• Screw the hose back onto the tap. Make
sure the connection is tight.
• Unscrew the hose from the machine. Keep
a rag nearby because some water may flow.
• Clean the filter in the valve with a stiff brush
or with the piece of cloth.
35°
• Screw the hose back to the machine and
make sure the connection is tight.
• Turn on the water tap.
Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, remove the
remaining water from the inlet hose and the
drain pump.
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
45°
21