Installation - Zanussi ZKG 2105 User Manual

Electrical connection
Voltage - Overall power - Fuse
Water Supply Pressure
Maximum Load
Maximum Dry Load
Spin Speed

Installation

Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
After removing all the
packaging, carefully
lay machine on it's
back to remove the
polystyrene base from
the bottom.
Unscrew the three
bolts.
26
Information on the electrical connection is given on the rating plate, on
the inner edge of the appliance door.
Minimum
Maximum
Cotton
Cotton
Cotton Big Capacity
Synthetic
Maximum
Remove the power
supply cable and the
drain hose from the
hose holders on the
rear of the appliance.
Slide out the relevant
plastic spacers.
0,05 MPa
0,8 MPa
6 kg
3 Kg
4 Kg
2 Kg
1000 rpm
Open the porthole
and remove the poly-
styrene block fitted on
the door seal and all
objects inside the
drum.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materi-
als under the machine to compensate for any
unevenness in the floor.
Fill the smaller upper
hole and the two
large ones with the
corresponding plastic
plug caps supplied in
the bag containing
the instruction book-
let.
www.zanussi.com