Personalisation; Daily Use - Zanussi ZWG 6165 User Manual

• Pour 2 litres of water into the main wash compart-
ment of the detergent drawer in order to activate
the ECO valve. Then run a cotton cycle at the highest
temperature without any laundry in the machine, to

Personalisation

Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously for
about 6 seconds , the acoustic signal is deactivated (ex-
cept if there is a fault). By pressing these 2 buttons
again, the acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unatten-
ded so you do not need to worry that children might be

Daily use

Load the laundry
Measure out the detergent and the fabric softener
Open the door by careful-
ly pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
remove any manufacturing residue from the drum
and tub. Pour 1/2 a measure of detergent into the
main wash compartment and start the machine.
injured by or cause damage to the appliance. This func-
tion remains enabled also when the washing machine is
not working.
There are two different ways to set this option:
1. Before pressing button 7 : it will be impossible to
start the machine.
2. After pressing button 7 : it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously
for about 6 seconds buttons 2 and 3 until on the dis-
play, the icon appears or disappears.
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked (the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by means of the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The se-
lector dial can be turned either clockwise or anticlockwise.
Turn the selector dial to position
gramme/to switch the machine OFF.
At the end of the programme the selector dial must be
turned to position , to switch the machine off.
or in the appropriate com-
to reset the pro-
7