Zanussi ZWG 6165 User Manual page 22

Water drainage
This appliance is designed to be permanently plumbed
into your home's drainage system using one of the fol-
lowing methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the "U" piece" supplied.
"U" piece supplied
Place the drain hose into your standpipe, which
should have an internal diameter of approximately 38
mm thus ensuring there is an air break between the
drain hose and standpipe.
When discharging into a standpipe ensure that the
top of the standpipe is no more than 90 cm (35.4'')
and no less than 60 cm (23.6'') above floor level.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre. The
joining piece must have an internal diameter of 18 mm.
22
38 mm (1.5")
standpipe
diamater
30 cm (12")
Min. 60 cm (23.6")
Max. 90 cm (35.4")
If your drain hose looks
like this (see beside) you
do not require the "U"
piece". Just push the
hose firmly in to the stand-
pipe.
2. Onto a sink outlet spigot.
If the outlet spigot has
not been used before, re-
move any blanking plug
that may be in place.
If you intend to drain the hose from the machine into
a sink, make sure that the sink is empty and the plug
hole is not blocked. Use the plastic "U - Piece" sup-
plied.
Special conditions
If the floor is carpeted or covered with crumbly or soft
material, insert a rigid support base under the feet to pre-
vent noise, vibration or displacement. The base should
protrude a few centimetres beyond the edges of the ap-
pliance.
Warning! The appliance should NOT be placed
on deep pile carpeting.
Note!
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
In the interest of the environment
The appliance should be connected to the FOUL drain-
age system, the water will then be taken to a sewage
Loop
Push the drain hose onto
the spigot and secure
with a clip, ensure a loop
is formed in the drain
hose (see above) to pre-
vent waste from the sink
entering the appliance.