Table of Contents
Advertisement
During the washing cycle the display shows a temper-
ature icon to indicate that the appliance has started
the heating phase of the water in the tub.
First use
• Ensure that the electrical and water connec-
tions comply with the installation instructions.
• Remove the polystyrene block and any material from
the drum.
• Before the first wash, run a cotton cycle at the high-
est temperature without any laundry in the machine,
Personalisation
Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 2 and 3 buttons simultaneously for
about 6 seconds , the acoustic signal is deactivated (ex-
cept if there is a fault). By pressing these 2 buttons
again, the acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unatten-
ded so you do not need to worry that children might be
Daily use
Load the laundry
Open the door by careful-
ly pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
5.3:
• Child safety lock
This device permits you to leave the appliance unat-
tended during it's functioning.
to remove any manufacturing residue from the drum
and tub. Pour 1/2 a measure of detergent into the
main wash compartment and start the machine.
injured by or cause damage to the appliance. This func-
tion remains enabled also when the washing machine is
not working.
There are two different ways to set this option:
1. Before pressing button 6 : it will be impossible to
start the machine.
2. After pressing button 6 : it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously
for about 6 seconds buttons 3 and 4 until on the dis-
play, the icon
appears or disappears.
Measure out the detergent and the fabric softener
7
Advertisement
Table of Contents
