Helpful Hints And Tips - Electrolux EWH 127310 W User Manual

Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to and then to the new pro-
gramme position. Start the new programme
by pressing the button 6 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 6 . After a
few minutes the light 8.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
few minutes the door can be opened (pay
Stand by : once the programme has finish-
ed after a few minutes the energy saving sys-
tem will be enabled. The brightness of the

HELPFUL HINTS AND TIPS

Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer's washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
to cancel a pro-
. After a
attention to the water level and temper-
ature!) .
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 6 .
At the end of the programme
The machine stops automatically. The dis-
play shows three blinking zeros (
Some acoustic signals sound. The pilot light
of button 6 , the pilot lights 8.1 and 8.2 go
off. After some minutes the light 8.3 illumi-
nates and the door can be opened.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 8.2 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 6 .
At the end of the programme, the light 8.2
goes off to indicate that the door can be
now opened. Turn the programme selector
dial to to switch the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
display is reduced. By pressing any button
the appliance will come out of the energy
saving status.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first
wash; they should therefore be washed sep-
arately the first time.
electrolux 11
).
.