Table of Contents
Advertisement
CHECK:
1)
Main gas line to manifold connection.
2)
Rotisserie
(I.R. Burner) gas line connection.
3)
Bulkhead and gas supply hose connection.
4)
Corregated
gas line to bulkhead connection.
Z_ WARNING:
If there is a leak at connection
(1,2, 3, or 4),
retighten
the fitting with a wrench and recheck for leaks with
soap and water solution.
if a leak persists after re-tightening
the fitting,
turn off the gas.
DO NOT OPERATE THE GRILL. Contact
the Customer
Service
Representative
in your area using the contact
information on
our web site. Log onto www.weber.com
®.
5)
Hose to regulator connection.
6)
Regulator to cylinder connection.
7)
Valves to manifold connections.
z_ WARNING:
if there is a leak at connections
(5, 6 or 7 ), turn
off the gas. DO NOT OPERATE THE GRILL. Contact
the
Customer
Service Representative
in your area using the
contact information on our web site.
Log onto www.weber.com
®.
When leak chocks are complete, turn gas supply off at the source and rinse connections
with water.
REINSTALL
CONTROL
PANEL
Parts required:
control panel, screws and burner control knobs.
Hook the top edge of the control panel onto the control panel brackets on either side of
the front of the cooking box.
Line up screws with screw holes on both the control panel bracket and the frame.
Tighten screws.
Place corresponding
control knobs onto the valve stems.
%
*The grill illustrated
may have
slight
differences
than the
model
purchased.
Advertisement
Table of Contents
