Venturer PLV31220S1 Instruction Manual page 17

CONNECTING A HIGH-DEFINITION (HD) SOURCE
High-Definition (HD) devices with component video output must be connected to the YUV
input.
Connect the component video cable and audio cable (not included) as shown.
Make sure you connect the component video cable and audio cable from the other equipment
(COMPONENT VIDEO OUT and AUDIO OUT) to this unit (COMPONENT VIDEO IN and
AUDIO IN -YUV IN).
f HD SOURCE 1
JWith component video output|
J (Digital Cable Box*, Satellite I
ToAUDIO INjacks J Receiver*,or external
I
(YUV IN) I, over-the-air
HD-Tuner).
J
* May require a subscription for
receiving HD channels.
Check with your cable/
satellite service provider for
details.
ToCOMPONENT ToCOMPONENT
VIDEO INjacks VIDEOOUT
(YUVIN) jacks
Note:
When connecting a DVD player to the television, the picture resolution is solely dependent
upon the resolution supported by the DVD player attached. DVD player resolutions vary from
480i to 1080i, and this television can support DVD players up to a maximum resolution of
1080i.
CONNECTING A PC
Connect the 15-pin D-SUB PC/VGA connector from your computer to the 15-pin D-SUB PC/
VGA input on this unit using a monitor cable and audio cable (not included) as shown.
Make sure you connect the cable
from the computer (PC Connector
and AUDIO - PC OUT) to this unit
(MONITOR / VGA and AUDIO -
PC IN).
ToAUDIO jack
(PC OUT)
_I_ To PC connector
E-17