Assembly; Unpackpressure Washer; Attach Handle And Accessory Tray - Troy-Bilt 2550 PSI Operator's Manual

E
Assembly
-_i ead entire operator's manual beforeyou attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, pleasecall the pressure washer helpiine at
(888) 611-6708. if calling for assistance, please havethe
model, revision, and serial number from the data tag
available.
UnpackPressure Washer
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensureyou have all included items prior to assembly.
Items in the cartoninclude:
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• NozzleExtension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Bottle
• Parts Bag (which includes the following):
• Safety Goggles
• Operator's Manual
• Owner's Registration Card
• Bag containing 3 Multi-Colored Spray Tips
• Spray Gun HolderWireform
• HandleFasteningHardwareKit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (4)
To prepare your pressurewasher for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
/ , / ,
(
i, !
7
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. insert carriage bolts (O) through holes from front of
unit and attach a plastic knob (E) from back of unit.
Tighten by hand.
.
----.i'_ J
Race accessory tray (F) over holes (G) on handle
(viewing from front of unit). Push the tree clips (H) into
the holes until they sit fiat against the accessory tray.
.
insert spray gun holder wireform (J) through hole on
left side of handle (viewing from front of unit). Hold
wireform in place and attach a plastic knob (K) from
inside of unit. Tighten by hand.
/,' /
/ /'
/,' /
/,' /,
/O /
/
/
//
/
, /
8 www.troybilt.com